Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section.
Installing gutter pops.
Hook one side of the chalk line to the nail at the start of the gutter run.
Dig a hole underneath your gutter downspout and place a catch basin in the hole.
Cut a triangular section from.
Then trim the first section of the gutter to length with tin snips.
Use a square and pencil to mark the gutter length and cut to the line.
We provide a fully licensed plumber to do all your gutter.
Secure it with eight pop rivets or sheet metal screws.
Begin by installing a slip joint splice on each end of an inside corner fitting.
Snap the sections together.
Wrap the aluminum strip tight around the underside of the gutter.
Form strip miter joint at corner cover the joint between two lengths of gutter at each corner with a strip miter a 3 inch wide strip of aluminum.
Project step by step 20 cutting the gutter.
Firmly hit the top of the nails with a hammer to drive them into each point.
Locate the endpoints and hold a nail over each.
It s much easier to join sections on the ground than to work from the top of a ladder.
Here are the steps to installing a pop up gutter drain system.
Slide the splices on as far as they ll go.