Installing A Window In A Wall With Vinyl Siding

Clearance below the sill.

Installing a window in a wall with vinyl siding.

If your new england home is in need of new windows and is already protected by vinyl siding special care may be needed to ensure that the installation process is a smooth one. Do not cut the vinyl off. Clearance on each window side. Next lock a scrap piece of siding into the panel below butting against the window.

The most important factor in determining whether existing siding will need to be removed for replacement window installation is the age and condition of the window. Push one end of longer pieces into the trim then bow the siding slightly and guide the other end into the trim. To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch. Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel.

Work the piece into the lock down its length. Mark the height needed allowing 1 4 in. Use this tool by inserting it where a piece of vinyl overlaps a piece below it and then sliding it across until you reach the end of. Remove the pieces of vinyl siding from around the window area.

Then slide it up and snap the butt into the locking edge of the piece below. Maneuvering long pieces of vinyl into place can be tricky. Holding the siding panel under the window mark the width of the opening on the panel allowing 1 4 in. Install siding at the top of a window or door in a similar fashion but this time set the siding on the window channel and use the window trim to mark the cut.

Extract nails keeping the vinyl pieces in place in order to prepare vinyl pieces to be removed. Corrugated pvc siding is used on many garden sheds garages and patio enclosures. To install a window you cut an opening and install framing to mount the window and trim the outer edges. The newly installed window will need to be trimmed out with j channel or j molding before the siding can be reinstalled.