Install Flashing Roof To Awning

Above the roof sheathing.

Install flashing roof to awning.

I cut the tape so that it laps onto the housewrap above and 3 in. Place the flashing between the joint of the house and the roof. A magnetic torpedo level will provide even mounting brackets and adequately adjusted roof brackets. Also take time to properly seal all edges of the mounting brackets with high quality silicone sealant.

Then nail the new l shaped flashing under the builder s felt but above the fascia board. When installing the roofing to the fascia it will either go under the exiting roofs gutters or the gutters will need to be taken off and the existing roof can either be extended. Method 1 installing an awning patio roof onto existing fascia. Begin by removing the shingles at the affected area and removing old flashing if present.

I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall. If siding on. After installing the brackets the installation process of the awning can vary based on the awning itself as well as the type of mounting. The video features union s advantage lok ii standing seam roofing panel which is.

Nail the upper edges of the flashing to the roof sheathing where the shingles were removed with 6 penny. Nail the flashing securely in place using roofing nails. Before we install the end wall flashing we have to apply tape sealant to the top of the z trim so that there s a water tight barrier between the end wall flashing and the top of the z. Position the flashing with the lower edges atop the carport roof panels along the transition.

How to install porch roof flashing. Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt. The final thing to do is install the end wall trim. Flexible flashing tape seals the eave to the wall.

This video shows how to install endwall flashing with standing seam panels. Try to keep the nails as flush as possible to the edges. If you already have faulty flashing installed you must remove it. The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.